It's Easier Than You Think!
Many Anglers struggle with Splicing.
It doesn't seem to matter if it's Leadcore or an Unleaded Leader material such as Pin Down, most people opt for a ready tied version.
But fear not! This easy to follow guide will have you splicing perfect leaders in no time!
1- Using a splicing needle thread the Pin Down Leader onto the needle
2- Bring the splicing needle out of the side of the Pin Down Leader and pull down onto the needle
3- Use the splicing needle to hook the tag end of the Pin Down Leader creating a loop
4- Slowly push the Pin Down Leader off the needle bringing the tag end through the middle
5- Bring the tag end all the way through & out of the first hole in the leader
6- Pull the tag end through until you have the desired loop size
7- Trim the tag end
8- Blob the tag end with a lighter
9- The finished leader should have a small loop & the tag end should pulled back in to the middle of the leader